Sony PCV-E302DS - Manual (Page 896)

10. Secure the drive to the drive holder using any two of the three holes on each side of the drive
holder (screws are provided with the new drive). Do not overtighten the screws.
11. Connect the second drive connector to the new drive.
12. Connect the second power connector to the new drive.
13. Place the drive holder against the inside of the front chassis and slide it back. Be sure to align the
slots on the drive holder with the tabs on the inside of the chassis. Be sure to slide the drive holder
back so that the tabs slip into the notch at the bottom of the slot.
Page 896