Sony ICS-SP30 - Manual (Page 22)

Copyright 2007 – Enseo, Inc.
22
Note:
During a firmware update, the Display MUST NOT be unplugged or turned off.
Doing so while firmware is being downloaded and upgraded on the device could
damage the unit and make it unusable.
If the firmware update was initiated by mistake, it will time out after 3 to 5 minutes.
Start Settings Update
To manually initiate a Clone Setting update, press the Right arrow button on the remote
from this menu line. NOTE: By selecting this item, the tuner will immediately begin
the process of downloading and storing settings stored on the Enseo Galileo
System Server.
Restore Factory Settings
This function allows the tuner to be reset to the factory settings. Changes, channel lineup
programming and other setup customizations will be lost and the tuner will return to
factory settings.
Read TV Settings
This function initiates a Read command in the ICS-SP30 to read the settings values in
the TV. This is used to collect Clone data for a System Clone through the Enseo Galileo
System Server.
Show Status
This menu item will activate a status window showing important information about the
display, tuner, firmware versions and other diagnostic data.