Atlantic Technology SP-8000 - Manual (Page 7)

6
SP-8000 Subwoofer Preamplifier
7
Instruction Manual
Remote Control Connecting Your Preamplifier
The Atlantic Technology SP-8000 is relatively simple to hook up.
WARNING: To prevent risk of electrical shock or damage to your equipment,
always unplug all component AC cords before proceeding with speaker
and component connections! The last step in wiring your system should be
plugging in the AC cords!
Input
Connect your system's sub output here; this jack may be labeled Sub,
Subwoofer, or LFE (Low Frequency Effects). Simply connect to the Input
jack on your preamplifier with high-quality shielded cables as shown in
Figures 6 and 7. Please consult your processor/receiver manual for fur-
ther information regarding the use of these outputs. If possible use the
XLR- type input (balanced).
Output
Connect a high quality shielded cable from here to the input of your
subwoofer's amplifier; if possible, use the XLR-type balanced output.
Remote Control and Connections
��� ��� ���
��� ���
����
����
�������� ����������
�
Preset Program EQ buttons
Select from 4 preset equalization settings in any sequence.
(page 14)
Reference EQ button
REF button returns the preamplifier to its flat/THX EQ settings
and returns the volume trim level to 0dB. (page 12)
MUTE button
Mutes the output of the preamplifier. Pressing again returns the
preamplifier to the previous volume setting
Level TRIM buttons
The  button increases and the  button decreases the volume
of the preamplifier above or below the preset reference level in 1dB
increments. (page 13)
1
4
3
2
1
4
3
2
Figure 5