Error messages, Error messages 36, Setting up utility for unit – Sony DVP-NW50 User Manual
Page 36: Selecting the playlist from your computer, Selecting “disc” from your computer
Chapter 3
Additional Information
36
Error Messages
If any of the messages below appear on your computer, check the following table to solve the problem. If any problem persists,
consult your nearest Sony dealer.
Setting up Utility for Unit
Message
Cause
Corrective action
This application has already started by
Another computer connected to
Only one computer at a time on a particular
another PC in the LAN
your network has already
network can run the Utility for In-Wall Unit software.
started the Utility for In-Wall
Unit software.
The same name is already being used
The Unit name you entered
All device names on the network must be unique.
is already in use by another
Enter a different name.
Unit on the network.
The same IP address is already being
Another Unit on the network is
The IP addresses of devices on the network
used
already using the IP address you
must be unique. Enter a different IP address.
entered.
All units’ set up will be overwritten.
This message appears when “OK”
Click “OK” to continue with overwriting the setup
OK ?
or “Apply” is clicked in the “Utility
data for all Units. Click “Cancel” to cancel overwriting
for In-Wall Unit Setup Menu”
of the setup data for all Units.
window for all Units.
Selecting the Playlist from your computer
Message
Cause
Corrective action
No Playlist found
The search did not find any playlists
matching the criteria you entered.
Application found a playlist incompatible
This message is displayed when
Convert the playlist into M3U-format.
with M3U. Please convert the playlist into
a playlist is found that is not
M3U format.
in M3U-format.
The selected playlist/track will be deleted.
This message is displayed when
Press “OK,” and a playlist or a track will be deleted.
Are you sure?
you try to delete a playlist or a
track.
Selecting “Disc” from your computer
Message
Cause
Corrective action
Can’t access the specified unit
The computer cannot access the
Contact your nearest installer to check your network
specified unit for some reason.
and electrical connections.
No Disc
This message is displayed if you
Insert a disc appropriate to the drive in the Unit or
select CD/DVD as the input source
computer.
when there is no disc mounted in the
drive of the selected Unit or computer.
Door is open
For safety reasons, closing a Unit’s
Go to the unit whose door is open, and close it.
door remotely is not supported.
Continue to the next page l