Precautions – Sony DSC-W560 User Manual
Page 135
Ta
ble
of
Op
e
MENU/Settin
In
135
GB
Precautions
Internal memory and memory card back up
Do not turn off the camera, remove the battery pack, or remove the memory card while the access lamp is
lit. Otherwise, the internal memory data or the memory card may be damaged. Be sure to make a backup
copy to protect your data.
On database files
When you insert a memory card without a database file into the camera and turn on the power, part of the
memory card capacity is used to automatically create a database file. It may take some time until you can
perform the next operation.
On image data compatibility
• The camera conforms with DCF (Design rule for Camera File system) universal standard established by
JEITA (Japan Electronics and Information Technology Industries Association).
• Sony does not guarantee that the camera will play back images recorded or edited with other equipment,
or that other equipment will play back images recorded with the camera.
Do not use/store the camera in the following places
• In an extremely hot, cold or humid place
In places such as in a car parked in the sun, the camera body may become deformed and this may cause a
malfunction.
• Under direct sunlight or near a heater
The camera body may become discolored or deformed, and this may cause a malfunction.
• In a location subject to rocking vibration
• Near strong magnetic place
• In sandy or dusty places
Be careful not to let sand or dust get into the camera. This may cause the camera to malfunction, and in
some cases this malfunction cannot be repaired.
On carrying
Do not sit down in a chair or other place with the camera in the back pocket of your trousers or skirt, as this
may cause malfunction or damage the camera.
On cleaning
Cleaning the LCD screen
Wipe the screen surface with an LCD cleaning kit (sold separately) to remove fingerprints, dust, etc.
Cleaning the lens
Wipe the lens with a soft cloth to remove fingerprints, dust, etc.
Cleaning the flash surface
Clean the flash surface before use. The heat of flash emission may cause dirt on the flash surface to become
discolored or to stick to the flash surface, resulting in insufficient light emission.
Cleaning the camera surface
Clean the camera surface with a soft cloth slightly moistened with water, then wipe the surface with a dry
cloth. To prevent damage to the finish or casing:
– Do not expose the camera to chemical products such as thinner, benzine, alcohol, disposable cloths,
insect repellent, sunscreen or insecticide.
– Do not touch the camera with any of the above on your hand.
– Do not leave the camera in contact with rubber or vinyl for a long time.
On operating temperatures
Your camera is designed for use under the temperatures between 0°C and 40°C (32°F and 104°F). Shooting
in extremely cold or hot places that exceed this range is not recommended.
Continued
r