Sony LF-X1 - Manual (Page 22)

Remo
te
L
o
c
a
tio
n
Se
tu
p
22 Step 9 Configuring the On-screen Remote Control
Pre-release version
(1) Select the make of connected device.
(2) Select the type of connected device.
(3) If the configuration above is correct, each time you click [Power], your
device should turn on or off.
After clicking [Power], it takes five seconds or more for the device to
respond.
If it does not work, make sure that the make and type are correct, and then
try again.
• Even if the power turns on and off correctly with [Power], other buttons
may not be enabled. If this happens, select [TV] from the Index. With the
on screen-remote, confirm that the buttons are enabled.
• Some devices may not have a [Power] button (e.g. DVR). In this case, as
well, use the on-screen remote to display [TV] and confirm that the buttons
are enabled.
When connecting two devices to the same connector
Make sure that the device connected directly to the base station is connected
as the first device.
When connecting an all-in-one video device, such as a
VCR+DVD player
The second remote control is automatically set when you select a device
displayed as all-in-one device from the [Type] list (e.g., Sony “VCR+DVD
player”). Click the [Switch] button on the on-screen remote control to switch
between the remote control of the VCR and that of the DVD player.
5
Click [OK] or [Apply].
z Tip
After configuring the remote control for Video 1 and Video 2, the [Video 1] and
[Video 2] options in the [index] window change to their set remote control names.
Notes
(1)
(3)
(2)