Sony LF-X1 - Manual (Page 12)

Pr
ep
arat
io
ns
P
rio
r to
A
c
c
ess
fr
om a
Re
mot
e
L
oca
tio
n
12 Step 4 Getting the Base Station Ready to Register Your Computer
Pre-release version
Step 4 Getting the Base Station Ready to Register
Your Computer
This step explains how to set up the base station before registering your remote
computer with it.
z Tip
While you are using the NetAV function to send video from the base station, you
cannot use the NetAV function from your home monitor or other computers to
access the base station. For details about the NetAV function and device
registration, refer to the LF-X1/LF-X5 operating instructions.
1
Set the monitor to the Home-Wireless setting.
Check that appears on the monitor.
2
Select [Settings], [Base station], [NetAV Settings], and then [Register Other
Monitors].
The [Register Other Monitors] screen appears.
3
Configure each setting.
.
(1) Select [Start].
After you select [Start], the current device status changes from
“Registration not accepted” to “Ready for registration” and an 8-digit
password appears. Jot down the password. You will need it to register
your computer to the base station.
(2) If you want to allow your computers to access the home base station
while you are watching TV, VCR or DVDs in “Home mode”, select this
check box.
z Tip
You can resume viewing on your home monitor in “Home mode”, by
selecting [Get AV], which interrupts the transmission to the computer
connected through the NetAV function.
(1)
(2)