Sony SLT-A35 - Manual (Page 28)

28
• Do not hold by any part of the lens that protrudes when zooming or focusing.
To remove the lens
To attach a lens hood
• A lens hood is not included with the DT 18-55mm F3.5-5.6 SAM. You
can use the ALC-SH108 (sold separately).
• When using a built-in camera flash, make sure to remove the lens hood to
avoid blockage of the flash light.
• When storing, turn over the lens hood and place it onto the lens
backwards.
1
Press the lens release button all
the way in and turn the lens
counterclockwise until it stops.
Lens release button
2
Attach the caps to the front and
rear of the lens and the body cap
to the camera.
• Before you attach them, remove dust
from them.
• A rear lens cap is not supplied with the DT
18-55mm F3.5-5.6 SAM Lens Kit. When
you store the lens without attaching it to
the camera, purchase the Rear Lens Cap
ALC-R55.
It is recommended that you use a lens
hood to reduce flare and ensure
maximum image quality.
Fit the hood into the mount on the end of
the lens barrel and rotate the hood
clockwise until it clicks.