Stacking and rack mounting, Stacking – ATEN ALTUSCN KH1516I User Manual
Page 22
KH1508i / KH1516i User Manual
10
Stacking and Rack Mounting
The KH1508i / KH1516i can be stacked on the desktop or rack mounted at the
front or rear of the rack. The following sections take you through the
procedures for each method.
Stacking
The KH1508i / KH1516i can be placed on any appropriate level surface that
can safely support its weight plus the weight of its attached cables. To place the
KH1508i / KH1516i, or to stack units if you are daisy chaining them, remove
the backing material from the bottom of the rubber feet that came with this
package, and stick them onto the switch’s bottom panel at the corners, as
shown in the diagram, below:
Note: To ensure adequate ventilation, allow at least 5.1 cm on each side, and
12.7cm at the back for power cord and cable clearance.