Sony SS-RG440 - Manual (Page 14)

14 GB
Other Operations
To change the AM tuning interval
(except for European, Russian,
Middle Eastern and Philippine
models)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding TUNER/
BAND on the unit, press ?/1 on the unit. When
you change the interval, all the AM preset
stations are erased. To reset the interval, repeat
the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power failure
occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 13).
1
Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2
Press PRESET –/+ (or . or > on
the unit) repeatedly to select the
desired preset station.
To Do this
Tune in a station
with a weak signal Follow the procedure described
in “Manual tuning preset”
(page 13).
Set another station
to the existing
preset number Start over from step 1. After
step 3, press PRESET –/+ (or
. or > on the unit)
repeatedly to select the preset
number you want to store the
other station.
Listening to the radio
Frequency Preset number