Sony VGC-V520G - Manual (Page 60)

Connecting the Wireless Mouse
Your VAIO ® computer is supplied with a wireless mouse. Before attempting to use the wireless mouse, you must enable
communication between the computer and the mouse. To connect your wireless mouse, it must be within 11 inches of the
computer
1 .
When attempting to connect the wireless mouse, confirm that the AA batteries (supplied) are properly inserted into
the mouse before your computer is turned on.
To connect the wireless optical mouse
1. Turn on your computer by pressing the power button.
2. Turn the wireless mouse over and slide the power button to the ON position.
3. Immediately press the CONNECT button on the right panel of the computer.
4. Press the CONNECT button on the bottom of the mouse.
Connecting the m ouse
5. Place the optical mouse on an appropriate surface to enable tracking.
Additional information about using a wireless optical mouse
A wireless optical mouse requires unobstructed communication with the system unit for proper operation.
 To maintain good communication, operate your wireless mouse within the distance limitations of the mouse 1 .
 Confirm that the supplied AA batteries are properly installed.
 Press the CONNECT button located on the right panel of the computer first, and then press the Connect button on
the bottom of the mouse.
 Verify the infrared receiver on the computer's front panel is free of obstructions that may prevent proper operation.
 Avoid using radio-controlled toys or equipment, CB radios, and other wireless devices in the area near your wireless
mouse. These devices may cause interference, causing your mouse to stop working properly.
 Do not place metal furniture near your computer or wireless mouse, as this may create interference, causing your
mouse to stop working properly.
Do not mix old (used) and new batteries when replacing batteries in the wireless mouse. Always use the same
Page 60