Sony KDL-26S3000R - Manual (Page 8)

8
(GB)
If you intend to install a TV that is not specified on page 2, be
sure to refer to the leaflet “Installing the Wall-Mount
Bracket” supplied with your TV.
Step 5:
Preparing for the
installation of the TV
1
Remove the screws from the rear
of the TV. Then detach the Table-
Top Stand from the TV.
Place the TV with its screen facing down on a stable
cloth-covered work surface.
For the following TV users:
KDL-26S30xx */KLV-26V300A
For the following TV users:
KDL-20S30xx *
* In the actual model names, the “xx” indicates
numbers and/or characters specific to each model.
Soft cloth
Soft cloth
Notes
• When removing the Table-Top Stand from the TV, lay the
display face down on a stable work surface that is larger
than the TV.
• To prevent damaging the surface of the LCD display, make
sure to place a soft cloth on the work surface.
CAUTION
• If pressure or shock is applied to the surface of the TV, the
LCD display may break or become damaged.
• Lay the display face down on a stable and level surface
with the Table-Top Stand hanging over the edge of the
surface. Having the display face and the base of the
Table-Top Stand on the same level surface will create an
unstable working condition and can damage the TV.
• When detaching the Table-Top Stand from the TV, hold the
Table-Top Stand securely with both hands.
2
Secure the Mounting Hook from
the left side of the rear of the TV.
1 Secure the Mounting Hook to the rear of the TV
temporarily, using the supplied two screws (+PSW4
× 12).
2 Be sure that both screws are tightened securely with
equal torque strength to the rear of the TV.
Notes
• If you install the right Mounting Hook first, it will be
difficult to adjust its angle. Install the left Mounting Hook
first.
• Be sure not to use any screws other than the supplied ones
(+PSW4 × 12) when securing the Mounting Hook.
When using an electric screwdriver, set the torque setting to
approximately 1.5 N·m {15 kgf·cm}.
Do not lift the Mounting Hook before the screws (two
screws each for left/right) are secured. This may distort the
Mounting Hook or the TV cabinet.
Screw
(+PSW4 × 12)
Mounting
Hook
Soft cloth