Subscribing the handset to a dect system – Avaya 4075 User Manual
Page 47
DECT system configuration
47
Subscribing the handset to a DECT system
You must subscribe the handset to at least one DECT system before you
can use the handset to make a call. The handset can operate with a
maximum of four DECT systems, for which the handset stores the name
of the system in a subscription record. Whenever the handset enters the
range of a subscribed DECT system, the name of the system appears on
the handset display.
Before you subscribe to a DECT system, obtain the following information
from your system administrator:
•
PARK code: A system ID that enables your telephone to differentiate
between DECT systems when more than one DECT system is
present.
•
DECT system name: The name of the system to which you subscribe.
After you enter the system name, it appears on the idle display.
•
Phone number: The local phone number assigned to your DECT
handset.
To subscribe your handset to a DECT system, perform the following
steps:
Attention:
If your supplier preinstalls the handset, you need not
subscribe your handset to a system. When the handset is
not yet subscribed to a system, the message “Register”
appears.
Use the PABX-PIN code to register the handset with a
DECT system.
Attention:
Once you have obtained your PIN code, you have 15
minutes to subscribe the handset. After 15 minutes have
elapsed, the PIN code is deactivated you must activate a
new one.
1. Open the
Connectivity
menu as shown in