3M MP7730 - Manual (Page 16)

3M ™ Multimedia Projector MP7730 16 © 3M IPC 2000
Operation
Startup
1. Plug power cord into wall socket.
2. Press the STANDBY/ON button
• The ON indicator blinks green and then stays green.
• The ON indicator will blink green during warm-up and lamp ignition.
(When power is turned off, there is a 90-second reset period before the STANDBY/ON button will
function again.)
3. Turn on all connected equipment.
✓
Note: Make all cable connections and line hookups with the
power off.
Power
1
2
✓
Note: If you have the Optional Video Module attached to the unit, press the Source button on the remote
to select the source of the signal to be projected onto the screen. The selected signal input is
displayed at the top right of the screen. The display will show the last selected input source before
power was turned off. (For more information, please refer to the Optional Video Module section of
this manual.)
Standby/On
Standby/On
Standby/On
Standby/ON