Sony VPL-VW11HT - Manual (Page 15)

15
(GB)
Connecting
When making connections, be sure to:
• turn off all equipment before making any connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are
not fully inserted often generate noise. When pulling
out a cable, be sure to pull it out by the plug, not the
cable itself.
Connecting with a VCR/15k RGB/
Component/Progressive
Component Equipment
This section describes how to connect the projector
with a VCR, external active speakers, and 15k RGB/
component/progressive component equipment.
Also refer to the instruction manuals of the equipment
to be connected.
Connecting
Setting up and pr
ojecting
Left side
CONTROL S IN VIDEO IN
TRIGGER
REMOTE
INPUT A
INPUT B
PLUG IN POWER
RS-232C
(FOR SERVICE USE)
S VIDEO
G/Y B/C B /P B R/C R/ P R SYNC/HD VD
VIDEO
G/Y B/C B /P B R/C R/ P R SYNC/HD VD
S-Video cable
(not supplied)
Video cable
(not supplied)
Active speakers
to video
output to S video
output
VCR
Left side
CONTROL S IN VIDEO IN
TRIGGER
REMOTE
INPUT A
INPUT B
PLUG IN POWER
RS-232C
(FOR SERVICE USE)
S VIDEO
G/Y B/C B /P B R/C R/ P R SYNC/HD VD
VIDEO
G/Y B/C B /P B R/C R/ P R SYNC/HD VD
15k RGB/Component equipment
to RGB/
component/
progressive
component
output
Pin Cable
(not
supplied)
Active speakers
Notes
• Set the aspect ratio using ASPECT in the INPUT
SETTING menu according to the input signal.
• To connect a 15k RGB/component/progressive
component equipment, select the COMPUTER/
COMPONENT/DTV YP
B
P
R
/DTV GBR in the
INPUT-A or INPUT-B in the SET SETTING menu
according to the input signal.
For details on setting, see page 27 (GB).
• You can connect a high definition equipment. The
connection method is the same as above.