Sony PCV-L630 - Manual (Page 29)

Configuring Your System 21
VGA Switch
You can enable or disable the onboard VGA controller if you install a
VGA PCI add-in card.
To enable or disable the onboard VGA, perform the following steps:
1
Remove the system cover (see “Removing the System Cover” on
page 24 ).
2 Set the VGA switch (SW6) to ON (Enable) or OFF (Disable). The
default is ON (also see
“Configuration Switches (SW)” on page 67).
3
Reinstall the system cover (see “Replacing the System Cover” on
page 25).
O N
1 2 3 4 5 6
KY0092.VSD
VGA switch
O
N
1 2 3 4 5 6
ON
OFF
SW