Securing the flat panel to the wall mount, Lateral shift adjustment – Sony SFM3 User Manual
Page 11
SFM3
Installation Manual
Page - 11 -
Securing the Flat Panel to the Wall Mount
WARNING: At least (2) qualified personnel are strongly recommended for installation of this product.
Failure to do so could result in serious injury and possible damage to the flat panel.
1.
Raise the flat panel with the mounting brackets secured to the flat panel and insert the top hooks from each
bracket to the rod on the wall plate (Figure 13).
Figure 13. Securing The Flat Panel
Lateral Shift Adjustment
1.
Make any lateral shift adjustment and lock it by tightening the two (2) ¼”-20 Phillips screws found on the
bottom of the mounting brackets (Figure 14).
2.
Use the foot leveler to adjust your plasma.
CAUTION: Do not over tighten the ¼”-20 screws to the rods.
Figure 14. Lateral Shift Adjustment
Wall Plate
TOP
BOTTOM
¼ - 20” Screw
Leveling Foot