Sony VGF-CP1U - Manual (Page 64)

6
VGF-CP1 Series 3-300-630-31(1)
Condition Cause/Remedy
[Cannot play tracks] is
displayed.  Some music files may not be played back depending on the file format.
[Cannot show the item] is
displayed.  This unit may not be connected to a network properly. Perform the
connection test.
 Select [ Information] in the Home screen, and press
(ENTER).
 Press OPTIONS.
 Select [Connection test] in the Options menu, and press
(ENTER).
 The connection test starts. Follow the on-screen instructions if
connection fails.
Web service is not displayed in
the list.  The server may not be set. Check the Server settings.
A server using software such
as “VAIO Media” is not
displayed in the list.  This unit or the server is not connected to a network. See the cause/
remedy of “[A connection error occurred] as displayed” in “Connecting
to Wireless Network” (page 51).
 The server is not active. Check the following:
 The server is turned on.
 The server status ([Start/Stop server]) is set to [Start].
 This unit is registered with the server. For registration, refer to the
Help section of the server software in use, or the operating
instructions supplied with the server.
 The server may not be recognized if this unit is turned on before
turning on the server. Select [Update information] in the Options menu
to update the list.
 If a computer is used as a server, check the following:
 The computer may be unstable. Restart the computer.
 This unit may not connect to a computer with an Internet
connection fire wall (ICF) function on. For fire wall information, see
the Help section for the security software in use.
 Register this unit to the server individually.
 Click [Start] in the computer used as the server, and click [All
Program]-[VAIO Media]-[Server Administration]-[VAIO Media Server
Settings] to start VAIO Media Integrated Server.
 Click [Access Control Settings] page, and click [Register].
 After starting the device registration wizard, put a check mark on
[Manually register the device by entering the MAC address], and
click [Next].
 Follow the instructions on the screen to register this unit.