Sony PCV-RZ20C - Manual (Page 48)

About Installing Memory
The amount of preinstalled memory may vary, depending on the system configuration you purchased. Your computer may
ship with all available memory slots filled. See the online specifications sheet for details about the amount of memory
installed in your computer. For memory replacement or upgrades, use only 2.5 V, 64-bit, PC2700 DDR-SDRAM Dual Inline
Memory Modules (DIMM).
You can purchase additional memory modules, accessories, and peripheral equipment from your local retailer.
Observe the proper safety precautions when you add or remove the memory in your computer. See Before
upgrading your computer .
Removing a memory module
1. Shut down your computer and turn off all peripheral devices, such as your printer.
2. Unplug your computer and all peripheral devices.
3. Remove the side panel. See About the Side Panel .
4. Gently place the unit on its side. If necessary, remove any cables, add-on cards, or other components to access
the memory module slots.
To remove the power supply (for PCV-RX series model only)
1. Remove the screw that secures the power supply unit to the chassis.
2. Pull the tab that releases the power supply from the chassis.
3. Slide the power supply unit up until it clears the chassis.
4. Rotate the power supply to an upside down position and rest it beside the chassis.
5. Locate the memory module(s) you wish to remove.
6. Push down on the latches, located on both sides of the module, to gently eject it from the slot.
7. Grasp one edge of the module and lift it out. Store the module in a static-free bag.
Gently handle the memory module by the sides only. Avoid touching the pins located at the bottom edge
of the module.
Rem ov ing/Installing m em ory (PCV- RZ series m odel)
Page 48