Avaya ABT35 - Manual (Page 67)

8 9
PAIRING
Pairing headset
with USB Bluetooth adapter
NOTE: The headset and USB Bluetooth adapter are paired to each other at the factory. However, if
you have purchased a USB Bluetooth adapter separately, or if you wish to use a replacement headset
with your existing adapter, the units must be paired.
Power on the headset. Insert the USB Bluetooth adapter into the USB port of your computer.
1. Simultaneously press the headset
listen volume adjust button marked
+ (volume up) and the call control
button. Release the buttons when
the indicator light begins to flash
red then blue.
NOTE: Take caution when manually pairing the USB adapter. Do not press hard. Please “pinch”
with both fingers rather than push on the adapter to avoid damage to the adapter or USB port.
2. Pinch the USB Bluetooth adapter
pairing/connect button for at least
2 seconds until adapter flashes red
and blue and begin pairing with your
Bluetooth headset.
2 sec.
INSTALLING PERSONOCALL ® SOFTWARE
Avaya PerSonoCall ® software provides the link between your Bluetooth headset and
compatible softphone applications on your computer. PerSonoCall software provides the
ability to remotely detect and answer/end a call from your softphone application via the
headset call control button.
Check the PerSonoCall compatibility list at www.avayaheadsets.com for the most current
information on softphone compatibility. If your softphone is not currently supported by
PerSonoCall, please refer to page 12.
1. With the CD inserted, go to the PerSonoCall main screen and click on “Install the
PerSonoCall Software”.
2. Your softphone may require you to choose which audio device you wish to use. Please
refer to softphone documentation for details.
NOTE: When the USB Bluetooth adapter is installed, it becomes the default audio device in
your computer. You can set preferences manually in the Windows ® operating system through
the Sounds and Audio Devices option in the Control Panel.
NOTE: Once installation is complete, we recommend that you set PerSonoCall to launch
whenever the Windows ® operating system starts.
System tray icons
After installing the software, one of the four system tray icons will appear in the tray
bar at the bottom of your screen showing the status of headset communication with
PerSonoCall.
: No headset detected
: Headset detected, no radio link to USB Bluetooth adapter
: Headset detected and radio link to USB Bluetooth adapter active
: Headset detected and radio link to USB Bluetooth adapter is locked on
Right-click on the headset system tray icon and choose “Options”. This will bring up
the PerSonoCall Basic Options and Current Status screens.
Refer to online application help for explanation details on the PerSonoCall software.
Configuration and status