Sony NEX-C3A - Manual (Page 78)

78 GB
Ta
ble of co
nt
en
ts
Sampl
e pho
to
se
ar
c
h
Men
u
search
Inde
x
1 [Menu] t [Brightness/Color] t [White Balance] t desired mode.
2 As necessary, [Option] t adjust the color tone.
Adjusting it toward + turns the image reddish and adjusting it toward – turns the image
bluish.
1 [Menu] t [Brightness/Color] t [White Balance] t [C.Temp./Filter].
2 [Option] t desired value.
1 [Menu] t [Brightness/Color] t [White Balance] t [Custom Setup].
2 Hold the camera so that the white area fully covers the AF area located in
the center, and then press the shutter button down.
The shutter clicks and the calibrated values (color temperature and color filter) are displayed.
3 To call the custom white balance setting, [Menu] t [Brightness/Color] t
[White Balance] t [Custom].
• If the flash is used when the shutter button is pressed, a custom white balance is registered with the flash
light taken into account. Take pictures with the flash in later shootings.
Preset white balance ( )
C.Temp./Filter
Color Temp. The higher the number, the more reddish the image, and the
lower the number, the more bluish the image. (The default
setting is 5500 K.)
Color Filter Based on using the set color temperature as the standard, the
color can be compensated to G (Green) or M (Magenta). The
higher the number, the more the color is compensated. (The
default setting is 0.)
Custom white balance
Note