Sony MZ-NF520D - Manual (Page 24)

24
Adjusting the sound quality
You can change the preset sound quality
and store the results in “SOUND1” or
“SOUND2”.
1
Press SOUND repeatedly to select
“SOUND1” or “SOUND2”.
2
During playback, press SOUND for 2
seconds or more.
The player changes to B (bass) setting
mode. Pressing jog lever changes the
player to T (treble) setting mode.
3
Slide the jog lever repeatedly to
adjust the level.
To switch “B” (bass) and “T”
(treble):
Press the jog lever.
To switch “SOUND1” and
“SOUND2”:
Press SOUND.
4
Press the jog lever to enter.
The sound settings are saved and the
playback display appears again.
To cancel the setting
Press SOUND repeatedly until nothing
appears in the display in step 1.
To cancel the procedure
Press and hold the DISPLAY button or x
button for 2 seconds or more.
For the player operation, see page 31.
z
• Settings can also be changed while playback
is momentarily paused (X).
• If the player is not operated approximately for
3 minutes, the current setting is stored and the
display automatically switches to normal
playback.
Note
When you use the Digital Sound Preset, the
sound may break or become distorted
depending on the settings or the track. In this
case, change the settings of the sound quality.
When you select bass-setting mode,
“B” appears. When you select treble
setting mode, “T” appears.
Example: While adjusting the bass
The cursor moves.
(Position: –2)
–4 ±0 +3
The sound can be adjusted in 8 steps
(–4, –3, ...±0, ...+2, +3).