Sony HT-SS360 - Manual (Page 54)

54 US
HDMI
The volume turns down when the
output method changes from the TV
speaker to the speakers connected to
the receiver.
• The Volume Limit function is working.
For details, see “Using the Volume Limit
function” (page 44).
The source sound input to the HDMI
jack on the receiver is not output from
the receiver or the TV speaker.
• Check the setting of CONTROL FOR
HDMI in the SET HDMI menu (page 31).
• Check the HDMI connection (page 18).
• You cannot listen to the Super Audio CD
by connecting HDMI.
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
The source image input to the HDMI
jack on the receiver is not output from
the TV.
• Check the HDMI connection (page 18).
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
The control for HDMI function does not
work.
• Check the HDMI connection (page 18).
• Make sure “CONTROL FOR HDMI” is
set to “CTRL ON” in SET HDMI menu.
• Make sure the connected component is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected component. Refer to the
operating instructions of the connected
component.
• Repeat the procedures of “Preparing for
the “BRAVIA” Sync” if you change the
HDMI connection, connect/disconnect the
AC power cord, or there is a power failure
(page 42).
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
• If you cannot listen to the sound of a
component connected to the receiver
– Select the appropriate input when you
want to watch a program on a
component connected via HDMI
connection to the receiver.
– Change the TV channel when you want
to watch a TV broadcast.
– Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna as shown below. If you connect
the receiver to an outdoor antenna, ground
it against lightning. To prevent a gas
explosion, do not connect the ground wire
to a gas pipe.
AM
ANTENNA
Receiver
To ground
Ground wire
(not supplied)
Outdoor FM antenna