Sony HMZ-T3W - Manual (Page 2)

HMZ-T3W 4-471-975- 11(1)
To loosen
To tighten
1
Raise the top headband
and the forehead
supporter.
The position of the forehead supporter is
adjustable.
The lowest position is standard.
2
Pull out the straps of
the top and bottom
headbands.
Hold down the button on the upper side of
each adjuster and pull out the strap on the
right.
3
Put the head mounted unit
on your head.
Lower the bottom headband to the base of
your head.
4
Tighten the headbands
loosely and adjust the
position of the head
mounted unit.
Push the strap into the adjuster on the top
and bottom headbands to fix the head
mounted unit.
Carefully adjust the unit left, right, up, and
down to find the best position for viewing
the centers of the screens.
5
Tighten the headbands
securely.
6
Put on the headphones.
If you normally wear glasses or contact lenses, wear them as usual during
use (with the exception of reading glasses). Note that watching with bifocals
may be less than optimal.
2
Adjust and Wear
For a Comfortable Fit
 Support the unit with your forehead and at two positions
on the back of your head.
 Do not rest it on your nose.
 Adjust the unit so that the screens are in front of your eyes.
 Place the battery unit in a stable position.
When you wear glasses or need further adjustment
Refer to “Fitting the Head Mounted Unit” of the “Reference Guide.”
Screen
All three “ ” marks
and the horizontal
line intersect.
One or more “ ”
marks and the
horizontal line do
not intersect.
1
Select a display language
(first time only).
Press the / button to
select a language, and then
press the MENU or
 button.
2
Adjust the lens span.
Slide each lens span adjuster until you can
see both screens clearly.
After adjustment, press the MENU button or
 button.
Tips
 If you cannot see the screen clearly after lens span adjustment,
start over from “2 Adjust and Wear.”
 If adjustment is difficult, try sliding both adjusters to the center
position before adjustment.
3
Check display alignment.
Confirm that all three “ ” marks and the
horizontal line intersect then press the MENU
or
 button.
It is acceptable if the “ ” marks and the
horizontal line intersect in a position other
than the center of the screen.
Note
 The “ ” marks and the horizontal line do not intersect if the
position of the head mounted unit is shifted. Readjust the
length of the headbands and confirm the position, referring to
“2 Adjust and Wear” and “
 Adjust the lens span.”
If even one of the “ ” marks and the horizontal line do not
intersect, refer to “Confirming Screen Alignment” of the
“Reference Guide.”
4
Follow the instructions
displayed on the screen.
Refer to the information on the screen for
operation.
5
Operate the playback
equipment.
The picture appears on the screen of the
head mounted unit.
Tips
 Adjust the volume using the VOL +/– button on the head
mounted unit.
 It is useful to keep the remote control unit for the playback
equipment at hand.
 Some functions of the playback equipment can be controlled
from this system. For details refer to “Control for HDMI” in
“General Setup” of the “Reference Guide.”
3
Set Up and View
Follow the instructions
displayed on the
screen for operations.
Resolving lack of audio, video, or 3D playback
1. Turn on the processor unit and the head mounted unit.
2. Turn the playback equipment off then back on.
If the playback equipment is a PlayStation®3, turn it off then
hold down the power button on the PlayStation®3 for at least 5
seconds (until you hear another beep) to restart it.
“PlayStation” is a registered trademark of Sony Computer Entertainment Inc.
Eye Screen
Battery unit