Sony SPOM1 - Manual (Page 5)

Installation Instructions SPOM1
5
INSTALL DISPLAY
The following procedure assumes that the proper interface
bracket for the display being mounted has already been
installed on the display.
If no interface bracket is present on display, install bracket to
display using the instructions included with the interface bracket
before proceeding.
If an interface bracket for the display being mounted needs to
be obtained, or additional assistance is required, contact a
Chief Customer Service representative by calling
1-800-582-6480 or by visiting www.chiefmfg.com.
1. Move mount faceplate to extended position by
grasping faceplate and pulling outward away from
wall. (See Figure 5)
WARNING: Keep hands and fingers away from all pinch
points when moving the mount from retracted to extended
position.
Figure 5 Extend Mount
2. Align mounting buttons on display with teardrop
mounting holes in mount faceplate (See Figure 6).
3. Move display forward until all four mounting buttons
are through teardrop mounting holes in faceplate, and
recessed area of mounting buttons is aligned with the
lower area of teardrop mounting holes in faceplate.
4. Lower display until the recessed area of all four
mounting buttons is seated in the lower area of
teardrop mounting holes in faceplate. (See Figure 6)
5. Move latching flag to the UP position to secure display
to mount assembly.
NOTE: If desired and install optional security screw and
locknut provided. The display can also be locked
in the retracted position by installing the optional
locking pin provided.
(See Figure 6) and (See Figure 7)
Figure 6: Install Display on Mount Assembly
Figure 7 Install Optional Locking Pin
Faceplate
Faceplate
Mounting Button
Latch Flag
Teardrop
Mounting Hole
(4 places)
Security Screw
Lock Nut
(On Display)
Locking Pin
Faceplate