Sony HT-CT260 - Manual (Page 20)

20 US
When the Sound Bar is to be placed
facing upward slightly or on a wall,
remove the two stands at the bottom of
the Sound Bar, as shown below.
You can install the Sound Bar on the
wall.
• Use screws that are suitable for the wall
material and strength. As a plaster board wall
is especially fragile, attach the screws
securely to a wall beam. Install the Sound
Bar on a vertical and flat reinforced area of
the wall.
• Be sure to subcontract the installation to
Sony dealers or licensed contractors and pay
special attention to safety during the
installation.
• Sony is not responsible for accidents or
damage caused by improper installation,
insufficient wall strength, improper screw
installation or natural calamity, etc.
1
Prepare screws (not supplied)
that are suitable for the holes on
the back of the Sound Bar.
2
Fasten the screws to the wall.
The screws should protrude 6 to
7 mm (approx. 1/4 inches).
Removing the stands
Installing the Sound Bar
on a wall
Notes
Stand
Hole on the back of the Sound Bar
4 mm
(3/16 inches)
more than 25 mm (1 inch)
5 mm
(7/32 inches)
10 mm
(13/32 inches)
592 mm
(23 3/8 inches)
6 to 7 mm
(approx. 1/4
inches)