Sony HT-CT260 - Manual (Page 40)

40 US
The remote control does not
function
• Point the remote control at the
remote control sensor on the
system.
• Remove any obstacles in the path
between the remote control and the
system.
• Replace both batteries in the remote
control with new ones, if they are
weak.
• Make sure you select the correct
input on the remote control.
OTHER
If ?/1 indicator on the subwoofer flash
in red.
Press ?/1 on the subwoofer to turn it
off, and check the following item.
• Is anything blocking the ventilation
holes of the system?
If “PROTECT” appears on the front
panel display.
Press ?/1 to turn off the system, and
check the following item after
“STANDBY” disappears.
• Is anything blocking the ventilation
holes of the system?
If the system still does not
operate properly after
performing the above
measures, reset the system
as follows:
Use buttons on the system for the
operation.
1
Press ?/1 to turn on the power.
2
Press ?/1 while pressing INPUT
and VOL – on the Sound Bar.
“RESET” appears and the system is
reset. AMP menu, sound field, etc.,
return to the default settings.
After checking the above item and fixing
any problems, turn on the system. If the
cause of the problem cannot be found
even after checking the above item,
consult your nearest Sony dealer.
Specifications
Formats supported by this system
Digital input formats supported by this
system are as follows.
Format Supported/Not
supported
Dolby Digital a
DTS a
Linear PCM 2ch 48 kHz
or less a