Sony STR-DE985 - Manual (Page 14)

14
US
STR-DE985/DE885 4-238-488-11(1) US
L
R
MULTI CH IN 2
L
R
L
R
FRONT SURROUND SUB
WOOFER
SUB
WOOFER
SUB
WOOFER
SURR
BACK
OUT
CENTER
MULTI CH IN 1
L
R
L
R
FRONT SURROUND
CENTER
SURR
BACK
PRE OUT 2ND ROOM
CONTROL
A1 II
CTRL S
OUT
CTRL S
OUT
CTRL S IN CTRL S
STATUS IN
Y
P B /B – Y
P R /R – Y
TV/SAT IN DVD/LD IN MONITOR
OUT
S–VIDEO
OUT
S–VIDEO
OUT
VIDEO OUT
S–VIDEO
IN
S–VIDEO
IN
S–VIDEO
IN
VIDEO IN VIDEO OUT
AUDIO IN AUDIO OUT
VIDEO IN VIDEO OUT
AUDIO IN
VIDEO IN
AUDIO IN
VIDEO IN
AUDIO IN AUDIO OUT
DVD/LD TV/SAT VIDEO 2 VIDEO 1
L
R
L
R
COMPONENT VIDEO
MONITOR
PHONO CD/SACD MD/DAT
L
R
L
R
IN IN IN OUT
TAPE
L
R
L
R
IN OUT
FM
75 Ω
COAXIAL y
CD/
SACD
IN
MD/DAT
IN
MD/DAT
OUT
TV/SAT
IN
DVD/LD
IN
COAXIAL
SIGNAL GND
y
AM
ANTENNA
DIGITAL
OPTICAL
L
R
L
R
+
–
CTRL S (STATUS) IN/OUT*
CONTROL A1
H
H
A
2ND ROOM OUT*
Other hookups
CONTROL A1 hookup
• If you have a CONTROL A1 compatible
Sony CD player, SACD player, tape
deck, or MD deck
Use a monaural mini-plug cord (not
supplied) to connect the CONTROL A1
jack on the CD player, SACD player, tape
deck, or MD deck to the CONTROL A1
jack on the receiver. Refer to “CONTROL
A1 control system” on page 46 and the
operating instructions supplied with your CD
player, SACD player, tape deck, or MD deck
for details.
Note
If you make CONTROL A1 connections from
the receiver to an MD deck that is also connected
to a computer, do not operate the receiver while
using the “Sony MD Editor” software. This may
cause a malfunction.
• If you have a Sony CD changer with a
COMMAND MODE selector
If your CD changer’s COMMAND MODE
selector can be set to CD 1, CD 2, or CD 3,
be sure to set the command mode to “CD 1”
and connect the changer to the CD jacks on
the receiver.
However, if you have a Sony CD changer
with VIDEO OUT jacks, set the command
mode to “CD 2” and connect the changer to
the VIDEO 2 jacks on the receiver.
* STR-DE985 only
01GB03HOOUS.p65 25/3/02, 02:45 PM 14