Sony HDR-UX10 - Manual (Page 22)

22
Step 2: Charging the battery pack
You can charge the “InfoLITHIUM”
battery pack (H series) (p. 130) after
attaching it to your camcorder.
b Notes
• You cannot attach any “InfoLITHIUM” battery
pack other than the H series to your camcorder.
1
Slide the POWER switch in the
direction of the arrow to OFF
(CHG) (The default setting).
2
Align the terminals of the battery
pack and your camcorder (1),
then attach the battery pack in the
direction of the arrow until it
clicks (2).
3
Connect the AC Adaptor to the
DC IN jack of your camcorder.
Open the jack cover, and connect the
DC plug of the AC Adaptor.
Make sure that the v mark on the DC
plug is facing to the v mark on your
camcorder.
4
Connect the power cord (mains
lead) to the AC Adaptor and the
wall outlet (wall socket).
The CHG (charge) lamp lights up and
charging starts. The CHG (charge) lamp
turns off when the battery is fully
charged.
5
After charging the battery pack,
disconnect the AC Adaptor from
the DC IN jack on your
camcorder.
To the wall outlet
(wall socket)
Power cord (Mains lead)
AC Adaptor
Battery pack
POWER switch
DC IN jack
CHG (charge) lamp
DC plug
Jack cover