Airaid 300-765 - Manual (Page 2)

Installation Instructions. Read Me!
1. Disconnect negative battery
cable. Loosen hose clamp on
intake tube at the factory airbox
end. For Jr. Kit, replace the
factory air filter with the Airaid
Premium Filter provided.
2. Disconnect the intake air
temperature sensor by squeezing
the tab on the connector.
3. With the 10mm socket,
remove 2 bolts from the base of the
resonator.
4. Remove the resonator and
tube from the vehicle.
5. With the resonator turned
over, carefully remove the air temp
sensor by pushing in, and turning
counter clockwise.
6. Install the urethane hump hose
on the factory airbox with the two
#60 hose clamps. (Leave clamps
loose.) Next install the reducer
(small side first with the #48 hose
clamp) on the throttle body. Install
the #52 hose clamp on the outside
of the reducer, and leave loose.
7. Install the grommet into the
hole in the MIT as shown.
8. Carefully install the air temp
sensor into the grommet installed
in step 7. Make sure it goes all the
way in.
9. Install the MIT into the hump
hose first, and then into the
reducer. Adjust the MIT so that it’s
up against the throttle body, and
then tighten all four hose clamps.
Reconnect the air temp sensor.