Removing the rear cover, Attaching the rear cover, Connecting directly to cable or an antenna – Sony KLV-23HR2 User Manual

Page 8: Cable box connections

Advertising
background image

8

Installing and Connecting the TV

75-ohm coaxial
cable (supplied)

Rear of TV

VHF/UHF

Basic Connections
(Connecting Cable TV or
an Antenna)

When connecting an antenna or cables, remove the
rear cover of the TV beforehand.

Removing the rear cover

1

Hold the lower right (or left) corner of the back
cover as illustrated below and pull it towards
you. Do the same to the remaining left (or right)
corner.

2

Hold the bottom edge of the cover with both
hands as illustrated and lift upwards.

Attaching the rear cover

Hold the rear cover as illustrated below, fitting the
four pegs on the rear cover into the corresponding
holes on the TV, then push the rear cover back onto
the TV.

Rear of TV

VHF/UHF

IN

OUT

Cable

Cable box

75-ohm coaxial
cable (supplied)

Connecting directly to cable or an
antenna

VHF only or VHF/UHF or cable

Note

It is strongly recommended to connect the antenna using a 75-
ohm coaxial cable to get optimum picture quality. A 300-ohm
twin lead cable can be easily affected by radio noise and the like,
resulting in signal deterioration. If you use a 300-ohm twin lead
cable, keep it away as far as possible from the TV.

Cable box connections

Use this hookup if:

• You subscribe to a cable TV system that uses

scrambled or encoded signals requiring a cable
box to view all channels, and

• You do not intend to hook up any other audio or

video equipment to your TV.

1

Connect the coaxial connector from your cable
service to the cable box’s IN jack.

2

Using the supplied 75-ohm coaxial cable,
connect the cable box’s OUT jack to the TV’s
VHF/UHF jack.

Also, set “Cable” to “On” in the

(Channel)

menu (See page 21).

Tips

• Your Sony remote control can be programmed to operate your

cable box (See “Programming the remote control” on page
34).

• To change channels using the cable box, set your TV to

channel 3 or 4 depending on the cable box channel output.

• If you will be controlling all channel selection through your

cable box, consider using the Channel Fix feature to set your
TV to channel 3 or 4 (See page 22).

Advertising