Sony HCD-GS100 - Manual (Page 15)

Tuner
15 US
Start over from step 1.
Follow the procedure described in
“Setting presets through manual
tuning”.
Stop setting
presets Press MENU.
Change the
preset station
Setting presets through
manual tuning
1
Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2
Press TUNING – or + repeatedly to tune
in the desired station.
3
Press MENU.
4
Press PRESET – or + repeatedly until
“MEMORY” appears, then press
ENTER.
A preset number appears.
5
Press PRESET – or + repeatedly to
select the desired preset number.
6
Press ENTER.
7
Repeat steps 1 to 6 to store other
stations.
Other Operations
To Do this
Tune in a station
with a weak
signal
To change the AM tuning interval
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding down
ENTER, turn the system back on. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the
same procedure.
Note
You cannot change the AM tuning interval in
Power Saving Mode.
Tips
• The preset stations are retained for about a day even
if you disconnect the mains lead or if a power
failure occurs.
• You can label the preset stations (see page 16).
• To improve broadcast reception, reorient or move
the supplied antennas near a window or outdoors.