Sony STR-DG600 - Manual (Page 30)

30 US
C:\Documents and
Settings\pc13\Desktop\JC060000_2662260114DG600_US\2662260116\US03CON_STR-DG600-
U.fm masterpage: Left
STR-DG600
2-662-260-11 (6)
5: Preparing the receiver
and the remote
Connect the AC power cord to a wall outlet.
* The configuration, shape and number of AC
outlets will vary according to the area code of the
receiver you purchased.
Notes
• Install this system so that the power cord can be
unplugged from the wall socket immediately in the
event of trouble.
• The AC OUTLET(s) on the rear of the receiver is a
switched outlet, which supplies power to the
connected component only while the receiver is
turned on.
• Make sure that the total power consumption of the
component(s) connected to the receiver’s AC
OUTLET(s) does not exceed the wattage stated on
the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons,
fans, or TVs to this outlet. This may cause a
malfunction.
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1
Press ?/1 to turn off the
receiver.
“TURNING” and “OFF” appears on the
display alternately and then
“COMPLETE” appears.
2
Hold down ?/1 for 5 seconds.
“PUSH” and “ENTER” appears on the
display alternately.
Connecting the AC power cord
ND BACK
L
–
NT A
L
–
FRONT B
R
L
+ –
AC OUTLET
AC power cord
To the wall outlet
AC OUTLET*
Performing initial setup
operations
?/1
AUTO CAL MIC
SPEAKERS (OFF/A/B/A+B)
PHONES
MEMORY/ ENTER CATEGORY MODE CATEGORY 2CH A.F.D. MOVIE MUSIC
MULTI CHANNEL DECODING
TUNING MODE DISPLAY INPUT MODE
INPUT SELECTOR TUNING – +
MULTI CH IN DIRECT
MASTER VOLUME
VIDEO 3 IN/PORTABLE AV IN
VIDEO L AUDIO R DIGITAL(OPT)
1,2
3
US01COV_STR-DG600-U.book Page 30 Thursday, March 16, 2006 11:32 AM