Sony VPL-VW1000ES - Manual (Page 68)

68
On-screen display
Remote control
The color of characters or
the picture is not
appropriate. c Select the desired color registration in “Panel Alignment” of the
Installation menu ( 1 page 57).
Image is left on the screen.
(image retention) c When high contrast non-moving images are displayed for a long
period of time, there may be some image retention on the
screen. This is only a temporary condition. Turning off the
power for a while will eliminate the retained image.
Symptom Cause and Remedy
Symptom Cause and Remedy
On-screen display does not
appear. c Set “Status” on the Setup menu to “On” ( 1 page 50).
c Check if the ON/STANDBY indicator should light in green.
When the ON/STANDBY indicator blinks in green, the unit is
starting up. Wait until it stops blinking and remains lit in green.
The model name does not
disappear from the screen. c The display mode of the unit may be set at the time of purchase.
Consult with your local dealer or qualified Sony personnel.
Input terminals do not
appear. c Set “Auto Input Search” on the Function menu to “Off” ( 1
page 54).
Symptom Cause and Remedy
The remote control does
not work. c Batteries could be weak. Replace them with new batteries
( 1 page 11).
c Insert the batteries with the correct polarities (1 page 11).
c If there is a fluorescent lamp near the remote control detector,
the unit may work improperly or inadvertently.
c If you use the optional 3D Sync Transmitter and point it to the
remote control detector of the unit, the remote control may not
work properly.
c Confirm the position of the remote control detector on the unit
( 1 page 8).
c Set “IR Receiver” to “Front & Rear” on the Installation
menu ( 1 page 55).