Sony DR-GA500 - Manual (Page 9)

9 GB Connection
Step 1-: Connecting a 5.1ch Sound Device
Connect the 5.1ch jacks of the processor by the supplied multi-channel cable. The EFFECT
function provides 7.1ch extended surround output from a 5.1ch input source.
1
Connect the processor to the
sound device as illustrated below.
Connecting jacks of the sound
device*
Cable
plug
names
MIC IN
Connect to MIC IN jack
 MIC
L/R OUT
Connect to L/R OUT jack
 L / R
Surround L/R OUT
Connect to SL/SR OUT jack
 SL / SR
Center/Subwoofer OUT
Connect to C/SW OUT jack
 C / SW
Not connected  SBL / SBR
* The jack name varies depending on the sound
device.
Multi-channel cable
(supplied)
Rear panel of processor
2
Slide the INPUT switch to “5.1ch.”
Front panel of
processor
3
Set the 5.1ch speaker mode in the computer.
For details on operation of your computer/sound device, refer to the operating instructions
for it.
Do not connect the USB cable with multi-channel cable at the same time when you connect
the processor to the computer. The computer sound setting may be switched to an
unintended device.