Alpine CDE-W203RI - Manual (Page 17)

15
-EN
Adjusting Subwoofer Level/Bass Level/
Treble Level/Balance (Between Left and
Right)/Fader (Between Front and Rear)/
Defeat
1
Press Rotary encoder (AUDIO) repeatedly to
choose the desired mode.
Each press changes the mode as follows:
SUBWOOFER* BASS LEVEL TRE LEVEL BALANCE
FADER DEFEAT VOLUME SUBWOOFER
Subwoofer: +0 ~ +15
Bass level: –7 ~ +7
Treble level: –7 ~ +7
Balance: L15 ~ R15
Fader: R15 ~ F15
Defeat: ON/OFF
Volume: 0 ~ 35
• If no operation is performed for 5 seconds after selecting the
SUBWOOFER, BASS LEVEL, TRE LEVEL, BALANCE, FADER or
DEFEAT mode, the unit automatically returns to normal mode.
* When the subwoofer mode is set to OFF, its level cannot be adjusted.
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting DEFEAT ON, previously adjusted settings of
BASS LEVEL and TRE LEVEL will return to the factory
defaults.
Setting the Bass Control
You can change the Bass Frequency emphasis to create your own tonal
preference.
1
Press SOUND repeatedly to select the BASS mode.
BASS TREBLE HPF BASS
2
-1 Press BAND/TA to select the desired bass centre
frequency.
80 Hz 100 Hz 200 Hz 60 Hz 80 Hz
Emphasises the displayed bass frequency ranges.
2
-2 Press SOURCE/ to select the desired bass
bandwidth.
Changes the boosted bass bandwidth to wide or narrow. A
wider setting will boost a wide range of frequencies above
and below the centre frequency. A narrower setting will
boost only frequencies near the centre frequency.
2
-3 *
1 Turn the Rotary encoder to select the desired
bass level (–7~+7).
You can emphasise or weaken the bass level.
3
Press and hold /ESC for at least 2 seconds to
return to normal mode.
• If no operation is performed for 15 seconds, the unit will return to
normal mode automatically.
• The bass level settings will be individually memorized for each
source (FM, MW (LW), CD, etc.) until the setting is changed. The
bass frequency and bass bandwidth settings adjusted for one source
are effective for all other sources (FM, MW (LW), CD, etc.).
• The function is inoperable when DEFEAT is set to ON.
* 1 The adjustment can also be made by pressing Rotary encoder. Refer
to “Adjusting Subwoofer Level/Bass Level/Treble Level/Balance
(Between Left and Right)/Fader (Between Front and Rear)/Defeat”
(page 15).
Setting the Treble Control
You can change the Treble Frequency emphasis to create your own tonal
preference.
1
Press SOUND repeatedly to select the TREBLE
mode.
BASS TREBLE HPF BASS
Sound Setting
BAND/TA
/ESC SOUND
Rotary encoder (AUDIO/LOUD)
SOURCE/
Setting the Bass Centre Frequency
Setting the Bass Bandwidth
Setting the Bass Level