Tuner, Remote commander – Sony STR-DG520 User Manual

Page 60

Advertising
background image

60

US

C:\Documents and
Settings\pc13\Desktop\JC071253_3284083111DG520_US\3284083111\US07OTH_STR-DG520-
U.fm

masterpage: Left

STR-DG520

3-284-083-11(1)

Recording cannot be carried out.

• Check that the components are connected

correctly.

• Select the source component using the

input buttons.

Tuner

The FM reception is poor.

• Use a 75-ohm coaxial cable (not supplied)

to connect the receiver to an outdoor FM
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground wire to a gas pipe.

Radio stations cannot be tuned in.

• Check that the antennas (aerials) are

connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.

• The signal strength of the stations is too

weak (when tuning in with automatic
tuning). Use direct tuning.

• Make sure you set the tuning interval

correctly (when tuning in AM stations
with direct tuning).

• No stations have been preset or the preset

stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 47).

• Press DISPLAY repeatedly on the receiver

so that the frequency appears on the
display.

Remote commander

The remote does not function.

• Point the remote at the remote sensor on

the receiver.

• Remove any obstacles in the path between

the remote and the receiver.

• Replace all the batteries in the remote with

new ones, if they are weak.

• Make sure you select the correct input on

the remote.

AM

ANTENNA

Receiver

To ground

Ground wire
(not supplied)

Outdoor FM antenna (aerial)

Advertising