Sony RCD-W10 - Manual (Page 17)

Recording/Editing
17
Insert the silence into the
end of the song (The function
of adding Post Gap)
You can insert the silence of 2 seconds between
the songs, when recording more than two tracks
at once. The silence is inserted according to the
following situations.
• When recording is stopped.
• When the disc of DECK A changes to the
next disc during Synchro-Recording. (RCD-
W50C only)
To use the function of adding Post
Gap
Set “Post Gap” of the setup menu to “On” during
stop. For details, see “Using the Setup Menu” on page
28.
Using the SBM (Super Bit
Mapping) function
When you record through the ANALOG input,
the SBM function enables you to record a 24-
bit high quality sound source by converting it
to a 16-bit source without reduction in sound
quality. This is made possible by incorporating
a noise-shaping filter in the 24-bit A/D
converter of this unit, which has a frequency
range designed to cover the range of human
hearing.
During recording pause, press SBM. The
indicator lights up.
When you press the button again, the function
is canceled and the indicator turns off.
Notes
• You cannot change the setting while recording.
• When you record through the DIGITAL OPTICAL
IN input, or when you make Synchro-Recording,
the SBM function is automatically canceled.
If “Auto Cut” appears in the
display (Auto Cut Function)
There has been no sound input for about 30
seconds during recording. The 30 seconds of
silence are replaced by a blank of about 3
seconds and the unit changes to recording
pause.
If the unit continues pausing for about 3
minutes after the Auto Cut Function activated,
recording stops automatically.
Note that this function does not activate if the
unit has started recording from a blank portion
or is synchro-recording from a CD on DECK
A.
Tip
You can turn off the Auto Cut Function. For details,
see “To turn off the Smart Space Function and Auto
Cut Function” below. Note that when you turn off the
Auto Cut Function, the Smart Space Function is also
turned off automatically.
If “Smart Space” appears in
the display (Smart Space
Function)
There has been an extended silence of 4 to 30
seconds in length during recording. When the
signal is input again, the silence is replaced
with a blank of about 3 seconds and the deck
continues recording.
Note that new track numbers may not be
marked for portions recorded while this
function is activated. Also, this function does
not activate even if there has been an extended
silence of 4 to 30 seconds in length when the
deck started recording from the blank portion.
To turn off the Smart Space Function
and Auto Cut Function
Set “Smart Space” in Setup Menu to “Off.” For
details, see “Using the Setup Menu” (page 28).
Note
When you turn off the Smart Space Function, the
Auto Cut Function is also turned off automatically.