Sony PCWA-C800S - Manual (Page 50)

"Link Rate (RX)"
Indicates the rate of frames received.
"Throughput (TX)"
Indicates the throughput of the current data transmission rate and fastest data transmission rate.
"Throughput (RX)"
Indicates the throughput of the current data reception rate and fastest data reception rate.
2. Wire le s s ON/OFF
Note
The follow ing buttons are not displayed if you are using Wireless LAN PC Card PCWA-C500 or PCWA-C300S.
"802.11b/g" button (if us ing the PCWA-C700, this button is "802.11b")
Enables/disables 802.11b/g or 802.11b (2.4 GHz) w ireless.
The O mark is green w hen this function is enabled and gray w hen disabled.
"802.11a" button
Enables/disables 802.11a (5 GHz) w ireless.
The O mark is green w hen this function is enabled and gray w hen disabled.
3. Othe r buttons
"Stre am ing M ode " button
This button enables/disables the optimal mode for transferring large files such as streaming movies. This mode is enabled w hen the button is pressed in and
disabled w hen the button is not pressed in. (The streaming mode cannot be used w hen connected to the access point using the WPA or WPA-PSK security
method.)
"Re ne w IP" button
Click this button to release/renew the current IP address that w as assigned to your computer and obtain a new one.
Note
This button is unavailable if the computer is configured w ith a static IP address.
"AP Se tting" button
If you click this button w hen the computer is connected to an access point netw ork, your Web brow ser starts and you can configure the access point and
monitor the netw ork status on the Access Point Setup Page that appears.
Note
The "AP Setting" button can only be used w hen you are using a w ireless LAN access point that supports this function .
"Show Graph"/"Hide Graph" button
Use this button to show or hide a graph displaying the communication status.
4. Graph
Displays the current communication status in the form of a graph.
"Signal Le ve l" che ck box
If you select this check box, the received signal level (strength) is displayed on the graph.
"Link Rate " che ck box
If you select this check box, the transmitted and received frame rates are displayed on the graph.
"Throughput" che ck box
If you select this check box, the throughput of the current data transmission and data reception rates are displayed on the graph.
Page 50