Tuner, Remote commander, Error messages – Sony STR-DG910 User Manual

Page 96

Advertising
background image

96

US

D:\CANNES\SONY_HA\JOB 2007\STR-DG910\IM_910_US\STR-DG910_data\GB06OTH_STR-
DG910-UC.fm

masterpage: Left

STR-DG910

3-094-430-11 (1)

Tuner

The FM reception is poor.

• Use a 75-ohm coaxial cable (not supplied)

to connect the receiver to an outdoor FM
antenna as shown below. If you connect
the receiver to an outdoor antenna, ground
it against lightning. To prevent a gas
explosion, do not connect the ground wire
to a gas pipe.

Radio stations cannot be tuned in.

• Check that the antennas are connected

securely. Adjust the antennas and connect
an external antenna, if necessary.

• The signal strength of the stations is too

weak (when tuning in with automatic
tuning). Use direct tuning.

• Make sure you set the tuning interval

correctly (when tuning in AM stations
with direct tuning).

• No stations have been preset or the preset

stations have been cleared (when tuning
by scanning preset stations). Preset the
stations (page 68).

• Press DISPLAY repeatedly on the

receiver so that the frequency appears on
the display.

Remote commander

The remote does not function.

• Point the remote at the remote sensor on

the receiver.

• Remove any obstacles in the path between

the remote and the receiver.

• Replace all the batteries in the remote with

new ones, if they are weak.

• Make sure you select the correct input on

the remote.

• When you operate a programmed non-

Sony component, the remote may not
function properly depending on the model
and the maker of the component.

Error messages

If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. Refer to the following
table to solve the problem. If any problem
persists, consult your nearest Sony dealer.
If an error message appears while you perform
Auto Calibration, see “When error codes
appear” (page 37)
to solve the problem.

PROTECT

Irregular current is output from the
speakers. The receiver will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.

AM

ANTENNA

Receiver

To ground

Ground wire
(not supplied)

Outdoor FM antenna

Advertising