Sony RCD-W50C - Manual (Page 20)

20
Turn on the indicator
OPTICAL
ANALOG
Recording on a CD-R or
CD-RW Manually
You can start recording from the end of the
existing material. Before recording, see “Notes
on Recording” on page 16.
When using the remote, set SELECT to CDR.
• After recording, you must finalize the disc.
Until the disc is properly finalized, it cannot
be played on any other machine. See
“Finalizing a CD-R or CD-RW” on page 24.
1
Turn on the amplifier and the sound
source, and then select the sound
source on the amplifier.
2
Press OPEN/CLOSE of DECK B and
place a recordable CD-R or CD-RW on
DECK B.
Press OPEN/CLOSE again to close the
disc tray.
3
Press INPUT repeatedly to select the
input connector.
REC z
INPUT
H
REC z
H
INPUT
SELECT
To record through
DIGITAL OPTICAL IN
ANALOG IN
To record the disc in DECK A, turn off
“OPTICAL” or “ANALOG.”
4
Press REC z .
DECK B stands by for recording.
5
Adjust the recording level, if necessary.
For details, see “Adjusting the Recording
Level” on page 21.
6
Press H .
7
Start playing the sound source you
want to record.
To pause recording
Press X. To resume recording, press the button
again or press H.
Note
Whenever you pause recording, a new track number
is added. For example, if you paused recording while
recording on track 4, the track number increases by
one and recording continues on the new track when
recording is resumed.
To stop recording
Press x.
“PMA Writing” appears while updating the
information of the disc before stopping the
recording.
Notes
• If you press REC z during recording, you can add
a track (page 22). The track must be longer than 4
seconds.
• When recording from more than one disc manually,
the silence between tracks may become longer. To
prevent this, use Synchro-Recording. (RCD-W50C
only)
• This unit uses the Serial Copy Management System,
which allows only first-generation digital copies to
be made of premastered software via the unit’s
digital input. Therefore you may not be able to
record a CD-R or CD-RW digitally through the
DIGITAL OPTICAL IN jack, depending on the
content being recorded.
• Because of the restriction of the Serial Copy
Management System (SCMS), you may not be able
to make digital recordings. In this case, use analog
recording through the ANALOG IN jack when you
record from other units. Or use Synchro-Recording
when you record from DECK A. (The recording
mode is automatically changed to analog recording.)
OPEN/CLOSE
x
x X
X
With the label side up