Sony DVP-SR101P - Manual (Page 13)

H
ook
up
s
13 US
8
Press ENTER.
The Setup Display for selecting the type
of jack used to connect your audio
component such as an amplifier
(receiver) appears.
9
Press X/x to select the type of jack
(if any) you are using to connect to
an audio component, then press
ENTER.
If you did not connect an audio
component, select “NO,” then go to step
13.
If you connected an audio component
using just an audio cable, select “YES:
AUDIO OUTPUT L/R,” then go to step
13.
If you connected an audio component
using a digital coaxial cable, select
“YES: DIGITAL OUTPUT.”
10
Press X/x to select the type of
Dolby Digital signal you wish to
send to your audio component.
If your audio component has a Dolby
Digital decoder, select “DOLBY
DIGITAL.” Otherwise, select “D-PCM.”
11
Press ENTER.
“DTS” is selected.
12
Press X/x to select whether or
not you wish to send a DTS signal
to your audio component.
If your audio component has a DTS
decoder, select “ON.” Otherwise, select
“OFF.”
13
Press ENTER.
Quick Setup is finished and connections
are complete.
YES
NO
Is this player connected to an amplifier
(receiver) ? Select the type of jack you
are using.
AUDIO OUTPUT L/R
DIGITAL OUTPUT
48kHz/96kHz PCM:
AUDIO SETUP
AUDIO DRC:
DIGITAL OUT:
DOLBY DIGITAL:
DTS:
STANDARD
ON
DOWNMIX: DOLBY SURROUND
DOLBY DIGITAL
D-PCM
DOLBY DIGITAL
AUDIO SETUP
AUDIO DRC:
DIGITAL OUT:
DOLBY DIGITAL:
STANDARD
ON
DOWNMIX: DOLBY SURROUND
DOLBY DIGITAL
DTS:
48kHz/96kHz PCM: OFF
OFF
ON