Sony RCD-W222ES - Manual (Page 19)

Recording/Editing
RCD-W222ES (US) 4-240-491-11(1) Actual page number:
19
High-Speed Synchro-Recording
You can easily make digital recordings from a
CD to a CD-R or CD-RW, faster than normal
speed Synchro-Recording.
You cannot monitor the recorded signal while
recording.
When using the remote, set SELECT to CDR.
1
Do Steps 1 to 3 of “Normal speed
Synchro-Recording” on page 18.
2
Press CD SYNCHRO HIGH repeatedly
to select the recording type, “NORM
SYNC” or “MAKE DISC.”
DECK B stands by for recording, and
DECK A stands by for playing. *
* The unit stands by for recording
immediately by pressing YES.
3
After “New Track” appears in the
display, press
N (or H on the remote)
(or X ) of DECK B to start recording.
High-Speed Synchro-Recording starts.
DECK A and DECK B will automatically
stop after recording.
To stop recording
Press x.
Playing from the beginning of
the disc after recording
1
Press x again while the unit is
stopped.
2
Press N (or H on the remote).
The unit starts playing from the first track.
Note
When you make Synchro-Recording in programmed
order, the recording speed automatically changes to
Normal.
CD SYNCHRO HIGH
CD SYNCHRO
HIGH
1
Press POWER.
2
Press OPEN/CLOSE of DECK B and
place a recordable CD-R or CD-RW on
the disc tray. Press OPEN/CLOSE of
DECK B again to close the disc tray.
“TOC Reading” appears. The unit starts to
read the TOC (Table of Contents) data and
shows the type of the disc on the deck in the
display.
3
Press one of the DISC 1-5 A buttons of
DECK A and place a CD on the disc
tray. Press
A of DECK A again to close
the disc tray.
When you perform Normal Synchro-
Recording (NORM SYNC), you can choose
the disc which you want to record, and the
play mode.
When you perform Make-Disc Synchro-
Recording (MAKE DISC), the disc in
DECK A is used to record.
4
Press CD SYNCHRO NORMAL
repeatedly to select the recording type,
“NORM SYNC” or “MAKE DISC.”
DECK B stands by for recording, and
DECK A stands by for playing.*
When you place a CD-R or CD-RW in the
deck, the unit optimizes itself for the best
possible recording and “OPC” appears on
the display shortly.
When “Not Blank” appears, make sure that
the blank disc is placed correctly.
* The unit stands by for recording
immediately by pressing YES. While
“OPC” appears, you cannot press YES.
5
After “New Track” appears in the
display, press
N (or H on the remote)
(or X ) of DECK B to start recording.
Synchro-Recording starts. DECK A and
DECK B will automatically stop after
recording.
To stop recording
Press x.
With the label side up
x
x
SELECT
H
N
05REC_RCD-W222.p65 02.6.20, 14:32 19