Avalon Acoustics AVALON INDRA - Manual (Page 10)

10
3 Wiring Instructions
Introduction
The crossover is housed in a sealed, non-accessible chamber in the bottom of
the speaker cabinet, to minimize the effect of vibration on the components.
The I
NDRA is equipped with high-quality binding post for connecting the
speaker cables. Spade lugs are recommended for all cable terminations.
Connecting the Speaker to the Amplifier
1. Place the speaker in its approximate location, then lay the speaker on its
side, using a soft surface to avoid scratching the finish.
2. Connect the speaker wires to the terminal block on the speaker bottom
(see Figure 3.1). Check to insure the correct polarity (positive lead connected
to the (+) terminal and negative lead connected to the (-) terminal.
Do NOT over-tighten the screws.
Figure 3.1 – Back view of the speakers showing the connections from the
amplifier to the loudspeaker. Check to insure the correct polarity (positive lead
connected to the (+) terminal and negative lead connected to the (-) terminal).