Philips GC4444 - Manual (Page 11)

 Empty the water tank (Fig. 16).
 Let the iron cool down in a safe place.
 Wind the mains cord and fix it with the cord binder (Fig. 17).
5 Store the iron on its heel on a stable surface.
Heat-resistant protective cover (gC4444, gC4440 only)
You can store the iron on the heat-resistant protective cover immediately after ironing. It is not
necessary to let the iron cool down first.
Do not use the heat-resistant protective cover during ironing.
1 Put the iron on the heat-resistant protective cover (Fig. 18).
 Insert the tip of the soleplate into the heat-resistant protective cover (1) and then press
down the heel of the iron ().
environment
Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 19).
guarantee & service
If you need information or if you have a problem, please visit the Philips website at www.philips.com
or contact the Philips Customer Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local
Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care
BV.
troubleshooting
If the appliance does not work or does not work properly, first check the list below. If the problem
is not mentioned in this list, the appliance probably has a defect. In that case we advise you to take
the appliance to your dealer or to an authorised Philips service centre.
Problem Possible cause Solution
The iron is plugged
in, but the soleplate
is cold.
There is a connection
problem.
Check the mains cord, the plug and the wall
socket.
The temperature dial is set
to MIN.
Set the temperature dial to the required
position.
The iron does not
produce any steam.
There is not enough water
in the water tank.
Fill the water tank (see chapter ‘Preparing for
use’, section ‘Filling the water tank’).
The steam control is set to
position 0.
Set the steam control to a position between
1 and 6 (see chapter ‘Using the appliance’,
section ‘Steam ironing’).
The iron is not hot enough
and/or the drip-stop
function has been activated.
Set an ironing temperature that is suitable
for steam ironing (2 to MAX). Put the iron
on its heel and wait until the temperature
light has gone out before you start ironing.
-
EnGlish 11