Sony D-NE336CK - Manual (Page 11)

Note on the car battery cord
The 3 V DC plug supplied with car battery
cord conforms to the proposed standards
of the Japan Electronics and Information
Technology Industries Association (JEITA).
Do not connect it to other players.
Polarity of the plug
(JEITA standards)
Replacing the fuse of the
car battery cord
If the CD player does not operate, check the
fuse. If it is blown, replace it as follows:
1
Turn off the CD player and remove
the cigarette lighter plug from the
cigarette lighter socket.
2
Remove the plug end by turning it
counterclockwise.
3
Remove the defective fuse from the
plug.
4
Insert a new fuse into the plug.
5
Replace the plug end by turning it
clockwise.
Remove
Fuse
Plug end
Cigarette lighter plug
Notes
• Be sure to use a fuse of the same amperage and
length as the one to be replaced. Never use a piece
of wire as a substitute for the fuse.
• If the fuse is blown again after replacing it, contact
your nearest Sony dealer. In such a case, bring the
defective fuse to the dealer with you.
Notes on the car connecting pack
• If no sound is heard or the car connecting
pack is ejected, change the direction of
playback on the car cassette deck.
• Never insert the cord end of the car
connecting pack into the cassette insertion
door. Otherwise, the cord may break or the
car cassette deck may be damaged.
• You cannot use the car connecting pack
with some car cassette deck.
• The cord should be placed so that it does
not hinder driving.
• To disconnect the cord from the CD player,
pull it out by grasping the plug. Never pull
the plug out by the cord.
• With some car cassette decks, you may
hear some rattling noise from the car
connecting pack. However, this is not a sign
of malfunction.
Continued 
11
Getting Started
D-NE331CK/NE336CK.GB.2-663-957-11(1)