Sony SLV-D570H - Manual (Page 108)

108 US Troubleshooting
DVD Troubleshooting
Symptom Remedy
Pi
c
tur
e
There is no picture/picture noise
appears. • Re-connect the connecting cord securely.
• The connecting cords are damaged.
• Check the connection to your TV (page 14) and switch
the input selector on your TV so that the signal from the
player appears on the TV screen.
• The disc is dirty or flawed.
• If the picture output from your player goes through your
VCR to get to your TV or if you are connected to a
combination TV/VIDEO player, the copy-protection
signal applied to some DVD programs could affect
picture quality. If you still experience problems even
when you connect your player directly to your TV, please
try connecting your player to your TV’s S-VIDEO input
(page 32).
• You have set the player to progressive format (the
PROGRESSIVE indicator lights up in orange) even
though your TV cannot accept the progressive signal. In
this case, set “Progressive” to “Off” (page 64).
• Even if your TV is compatible with progressive format
(480p) signals, the image may be affected when you set
the player to progressive format. In this case, set
“Progressive” to “Off” and the player is set to normal
(interlace) format (page 64).
• COMPONENT VIDEO OUT jack is not used or
“Progressive” of the “SCREEN SETUP” menu is not set
correctly while the PROGRESSIVE indicator lights up in
orange. Check the setting (page 62) and connection
(page 32).
There is no picture or the picture
noise appears when connected to the
HDMI OUT jack. • Try the following: 1Turn the DVD-VCR off and on
again. 2Turn the connected equipment off and on again.
3
Disconnect and then connect the HDMI cord again.
• If the HDMI OUT jack is used for video output, changing
the “HDMI Resolution” setting in the “SCREEN
SETUP” menu may solve the problem (page 63).
Connect the TV and the recorder using a video jack other
than the HDMI OUT, and switch the TV’s input to the
connected video input so that you can see the on-screen
displays. Change the “HDMI Resolution” setting in the
“SCREEN SETUP” menu, and switch the TV’s input
back to HDMI. If the picture still does not appear, repeat
the steps and try other options.
• The DVD-VCR is connected to an input device that is not
HDCP compliant (page 32).
Even though you set the aspect ratio
in “TV Type” of the “SCREEN
SETUP” menu the picture does not
fill the screen. • The aspect ratio of the disc is fixed on your DVD.
There is no picture from your VCR
connected to the LINE IN jacks. • The DVD player must be in standby mode to view
pictures from your VCR.