Sony PEG-NZ90 - Manual (Page 23)

23
Performing the initial
settings
Performing the
initial settings
The first time you turn on your CLIÉ handheld, you are required to make initial settings.
Follow the on-screen instructions to configure the initial settings and to get accustomed to
operations on your CLIÉ handheld.
1
Slide the POWER switch.
Your CLIÉ handheld turns on, and the Welcome screen is displayed.
Tip
If you cannot turn on your CLIÉ handheld
• Is the HOLD switch (page 34) set to HOLD?
• Did you charge your CLIÉ handheld following the steps on page 19?
b
For details, refer to the supplied manual “Troubleshooting Q&A.”
• If you cannot turn on your CLIÉ handheld even after charging it, perform a soft
reset (page 40).
Slide the POWER switch
b
Continued on next page
• • • • • • • • • • • • • • • • • • • • • • • • • • •