Sony MHC-NX1 - Manual (Page 21)

21
PROGRAM
1
Press CD, then place a CD.
2
Press PLAY MODE repeatedly until
“PROGRAM” appears in the
display.
3
Press one of the DISC 1~5 buttons to
select a CD.
To programme all the tracks on a CD at
once, proceed to step 5.
4
Turn the jog dial until the desired
track appears in the display.
5
Press ENTER.
The track is programmed. The last
programmed track and the total
programmed track number appear,
followed by the total playing time.
6
To programme additional tracks,
repeat steps 3 to 5.
Skip step 3 to select tracks from the
same disc.
7
Press ·.
All the tracks play in the order you
selected.
3
PROGRAM
To cancel Programme Play
Press PLAY MODE repeatedly until
“PROGRAM” or “SHUFFLE” disappears
from the display.
To Press
Check the
programme
Clear a track
from the end
Clear a specific
track
Add a track to
the programme
Clear the entire
programme
Tips
• The programme you made remains in the CD
player even after it has been played back. Press
· to play the same programme again.
• If “--.--” appears instead of the total playing time
during programming, this means:
– you have programmed a track number
which exceeds 20
– the total playing time has exceeded 100 minutes.
Disc number
Track number
Total playing time
The last programmed track
CHECK on the remote
repeatedly. After the last
track, “CHECK END” appears.
CLEAR on the remote in
stop mode.
CHECK on the remote
repeatedly until the number of
the track to be erased lights up,
then press CLEAR.
1 Select the disc tray with a
DISC 1~5 button.
2 Select the track by turning
the jog dial.
3 Press ENTER.
π once in stop mode or twice
while playing.