Ultra Start 32xx Series - Manual (Page 4)

Remote Starting
Remote Star ter Functions
Remote Stop
Idle Mode
Extended Run Time
Turbo Timer Mode
Page 4
OWNER’S GUIDE
2WAY REMOTE VEHICLE STARTER
1.Press and release Button #3 on the remote transmitter.
2.The Park lights will flash and the horn (optional) will honk one time.
3. The remote will beep 3 times and the key icon will begin flashing.
4.When the vehicle has started, the system will flash the park lights four times
then remain “On” while the vehicle is running. (Normally 15 minutes)
5. The Runtime Bar Graph will appear on the LCD and begin counting down.
6. The vehicle will run for the programmed runtime. (Normally 15 minutes).
Never remote start if the vehicle is parked in a garage or attached carport!
Operate in a well ventilated area only.
Note: If the remote starter fails to start, the park lights will flash a Trouble
Shooting Code. Count the number of flashes and refer to the Diagnostics Chart
1.Press and hold Button #3 for three seconds. The remote starter will shut down.
2.The park lights will flash two times and the horn (optional) will honk two times.
Note: Pressing the brake pedal or opening hood will also stop the vehicle.
1.Press and release Button #1 while the vehicle is running by the ignition key.
2.The park lights will turn on and the horn (optional) will honk once.
3. The Remote will beep and the Run Time Bar Graph will light up.
4.Turn the ignition key “off” and the vehicle will continue to run.
5. Exit the vehicle and leave it running safely without the keys in the ignition.
1.Press and release Button #4 while the vehicle is running by the ignition key.
2.The park lights will turn on and the horn (optional) will honk once.
3. The Remote will beep and the Run Time Bar Graph will light up.
4.Turn the ignition key “off” and the vehicle will run for approximately 2 minutes .
5. Exit the vehicle and leave it running safely without the keys in the ignition.
1.Press and release Button #3 while the vehicle is running under the remote
starter. The park lights will flash and the horn (optional) will honk to confirm the
runtime has been extended. The runtime will reset (normally 15 minutes).
Note: The Run timer is not updated with this feature.
1 2 3
4
1 2 3
4
1 2 3
4
1 2 3
4
1 2 3
4